[pvrusb2] Re: [linux-usb-devel] Re: BUG?: VIA IDE transfer-rate problem

[Helmut Toplitzer]

Hi again!

Ok. Maybe this is of interest too:

lsusb shows the following changes when disconnecting
the usb-storage and keeping the pvrusb2 device connected:

@@ -300,11 +162,11 @@
   bPwrOn2PwrGood       10 * 2 milli seconds
   bHubContrCurrent      0 milli Ampere
   DeviceRemovable    0x08
-  PortPwrCtrlMask    0xe8
+  PortPwrCtrlMask    0x68
  Hub Port Status:
    Port 1: 0000.0503 highspeed power enable connect
    Port 2: 0000.0100 power
-   Port 3: 0000.0503 highspeed power enable connect
+   Port 3: 0000.0100 power
    Port 4: 0000.0100 power
    Port 5: 0000.0100 power
    Port 6: 0000.0100 power
@@ -366,7 +228,7 @@
   bPwrOn2PwrGood        1 * 2 milli seconds
   bHubContrCurrent      0 milli Ampere
   DeviceRemovable    0x08
-  PortPwrCtrlMask    0xe8
+  PortPwrCtrlMask    0x68
  Hub Port Status:
    Port 1: 0000.0100 power
    Port 2: 0000.0100 power
@@ -428,7 +290,7 @@
   bPwrOn2PwrGood        1 * 2 milli seconds
   bHubContrCurrent      0 milli Ampere
   DeviceRemovable    0x08
-  PortPwrCtrlMask    0xe8
+  PortPwrCtrlMask    0x68
  Hub Port Status:
    Port 1: 0000.0100 power
    Port 2: 0000.0100 power
@@ -490,7 +352,7 @@
   bPwrOn2PwrGood        1 * 2 milli seconds
   bHubContrCurrent      0 milli Ampere
   DeviceRemovable    0x08
-  PortPwrCtrlMask    0xe8
+  PortPwrCtrlMask    0x68
  Hub Port Status:
    Port 1: 0000.0100 power
    Port 2: 0000.0100 power