[pvrusb2] remote control
Roger J. Allen
rja at firkraag.rogera.net
Sun Sep 11 18:53:34 CDT 2005
On Sun, 11 Sep 2005, Per Christian Henden wrote:
> On Sunday 11 September 2005 12:53, Andreas Korinek wrote:
>> Hi folks,
>> does anyone know how to set up the remote control support for the device?
>> I installed lirc and when I modprobe lirc_i2c I get the following in dmesg:
>> lirc_dev: IR Remote Control driver registered, at major 61
>> lirc_i2c: chip found @ 0x18 (Hauppauge IR)
>> pvrusb2 i2c_attach [client=Hauppauge IR @ 0x18 id=0xf3]
>> lirc_dev: lirc_register_plugin: sample_rate: 10
>> Looks good so far, but when I start lircd, there are no signals being
>> received, nothing happens.
> Same thing over here,
> and I get this error in /var/log/lircd
> Sep 11 13:13:14 b105c lircd 0.7.2: lircd(hauppauge) ready
I'm using Fedore Core 4 and atrpms with the latest updated kernel:
What do your /dev/lirc* files look like?
Does lsmod show lirc_i2c?
Can you try running irw before this next client tries to use it?
Was the client started by root?
> Sep 11 13:14:41 b105c lircd 0.7.2: accepted new client on /dev/lircd
> Sep 11 13:14:41 b105c lircd 0.7.2: could not get file information
> for /dev/lirc
> Sep 11 13:14:41 b105c lircd 0.7.2: default_init(): No such file or directory
> Sep 11 13:14:41 b105c lircd 0.7.2: caught signal
> I'm using the lircd.conf and lircrc that comes with the driver in the misc/
When I installed the pvrusb2 drivers, I only used the pvrusb2.ko and
saa7115.ko modules. The other modules were already installed by FC4.
I don't know if that would make a difference.
Roger J. Allen Voice: (312)-587-0690
Internet: rja at rogera.net FAX: (312)-587-0691
More information about the pvrusb2